首页 > 推广型号列表 > LT1930AES5

LT1930AES5

LT1930AES5资料
	LT1930AES5 PDF Download

File Size : 116 KB Manufacturer:LINEAR Description: The melting temperature of solder is higher than the rated temperature of the device. When the entire device is heated to a high temperature, failure to complete soldering within a short time could result in device failure. Therefore, the following items should always be observed in order to minimize the thermal stress to which the devices are subjected. • Always preheat the device. • The delta temperature between the preheat and soldering should be 100C or less.* • When preheating and soldering, the temperature of the leads and the case must not exceed the maximum temperature ratings as shown on the data sheet. When using infrared heating with the reflow soldering method, the difference shall be a maximum of 10C. • The soldering temperature and time shall not exceed 260C for more than 10 seconds. • When shifting from preheating to soldering, the maximum temperature gradient shall be 5C or less. • After soldering has been completed, the device should be allowed to cool naturally for at least three minutes. Gradual cooling should be used as the use of forced cooling will increase the temperature gradient and result in latent failure due to mechanical stress. • Mechanical stress or shock should not be applied during cooling.

	1PCS	100PCS	1K	10K
价格


型号：LT1930AES5 厂家：LINEAR 封装：SOT-23 批号：08+ 数量：17 说明：QQ：104735486 611606076


运费：运费到付10.00元（快递）20.00元（顺风）所在地：深圳新旧程度：